List Price: $9.99
Price: $8.25 You Save:$1.74 (17%)
Description
3/8in diameter; use for training satellite dish, TV antenna or cable.
Customer Reviews
Inadequate Ground Rod does fine in AZ
We needed to support a ground for out RCA ANT751 television antenna. Our soil is soft clay, and while I could drive down an eight-foot rod, I preferred the shorter idea. However, that size wasn't available locally. This one took a while to arrive, but it had the grounding connector already fond of. FYI, I used the recommended method of driving the rod in, pulling it out and then filling the hole with water. Repeated, this method sinks the rod as occupied as desired without any difficulty getting through the earth. I buried mine leaving only about six...
May 14, 2011
(Arizona USA) | Helpful Votes: 3 | Rating: 4
Gound Rod
Thanks. Delivered before expected. What else can you say about a groundwork rod? The purchase was easy and very reasonably priced.
A Copper Rod is...
A copper rod is, well, a copper rod. This one is a thimbleful short at 3 feet to meet code for an electrical installation (8 feet), for bush-leaguer radio use it is perfect. It has a rounded top, for hammering, and a clamp to attach the ground strap. What more could you expect or ask for?The only grumble I had, which I've already written about, was the packaging. Instead of putting this in a tube, the supplier used a box, a huge box stuffed with hang wallpaper. It wasn't enough & the rod was sticking through about 6 inches. Fortunately it still arrived in perfect condition.
January 19, 2012
(Lisle, IL USA) | Helpful Votes: 0 | Rating: 5
If you're ever goaded by weak cable TV or cable modem signals--often caused by older cable wiring in your refuge--then Motorola's in-line broadband drop amplifier makes a great solution. Too your weak signal up to 32 times with this easy to install device, and leave the frustration behind.
Leg up your weak cable or Internet signal up to 32 times with this easy to install mark of cadency.
Click to view a local-power install diagram.
Click to view a far-fetched-power install diagram.
Boost Your Signal
Make your signal strength up to 32 times more potent in a snap, to enhance analog and digital picture quality, improves cable modem speech, and reduce lost data. This device also allows you to optimize multiple broadband devices in your stingingly--televisions, cable set-top boxes, cable modems, VCRs, and digital radios--all from one handy cable.
No Tools Required
This amplifier is a breeze to install, with no tools are required. All connections, including the AC adapter, are straightforward F-type coaxial ports, so everything screws right in. This also enables local or remote powering.
Steadfast Construction
The BDA100 features Gallium Arsenide technology for improved distortion and rumpus performance, and built-in diplex filters for two-way operation.
A weather seal and protective coating style it work for both indoor or outdoor applications, and it boasts -6 kV surge resistance. Each BDA100 is housed within a good fettle aluminum die-cast housing and utilizes a Motorola P-Series Auto-Seize F-Connector for climactic reliability.
What's in the Box
BDA100 Amplifier, AC Adapter, Two Coaxial Cables, User's Manual
Customer Reviews
Keen Picture
Ever since my rope company installed digital cable in my house I have had picture problems. The analog pictures were grainy and half of the digital pictures didn't be awarded pounce on in. They just said they would arrive shortly but never did. Numerous calls to the cable company slipshod to come up with a permanent fix. So I decided to take matters in my own hands. Other boosters made things worse. When I saw that this one worked with digital as well as analog I stony to give it a try. I first hooked it up from the cable box to the vcr and got no improvement. So I tried hooking it up where the signal first came in before the cable reciever and it worked magnificently. Analog pictures are clearer than ever and all the digital pictures come in. No more "Please Wait" screens. I am mad that my boring cable company refused to do this but I am thrilled to finally have what I pay for! Great product!
August 26, 2003
(Virginia, Chantilly USA) | Helpful Votes: 214 | Rating: 5
Facts in fact about signal booster
As for the population writing the other reviews on this product, you should not speak if you know nothing about Broadband. First of all, this booster will NOT increase your docsis telegraph modem speeds, no matter what you hear. This amplifier, installed correctly (at the entry question of your home) will boost your forward signal by +15db (allowing return signals to out of date). Most cable modem operating level ranges are +15 to -15, so if your within that range on your cablegram modems operating frequency (for example 705mhz) there is no need for a booster. If you are on the treshhold of timer, like -17db, then this amp will be beneficial to you. Your GUI on your cable modem will give you this reading (http://192.168.100.1 for benchmark). As for your cable reception, and amplifier can be helpful if you have multiple TV's, to make up for the loss that your splitters father. But again, this amp MUST be installed @ your cables entry point to your home. If you have a bad connection though, you will only...
April 9, 2004
| Helpful Votes: 483 | Rating: 5
Nicest Booster on the Market
Ex to purchasing the Motorola amp, I purchased and installed the TERK AMP-15, which worked very well (until the cable crowd did a disconnect recently and apparently short-circuited the input). Upon reconnecting my wire service, the cable-tv tech noted that my TERK AMP-15 was no longer working. Rather than straight order another TERK, I decided to check the alternatives. Checking the specs, I noticed the Motorola Timer Booster is a similar product, however the specs are much better (2.5 dB max Noise Figure vs. 3.5 dB max for the TERK) and the Motorola uses the most avant-garde technology available (Gallium Arsenide). Also, the Motorola amp includes a 6kV surge resistant sketch out (meets the 6kV IEEE C62.41-1991 and 1 kV Combination Wave surge for all ports). I did not find surge safeguard mentioned in the TERK spec. Another difference is the Motorola provides a slightly wider bandwidth (52-1000 MHz) and operates at deign dc voltage (12VDC). These differences indicate a highly...
December 18, 2005
| Helpful Votes: 107 | Rating: 5
Ground Wire
There was the on one occasion when populace had to search for Ground Wire at specific stores and shopping centres but today with the supporter of internet, you can betray for your selected Cables to Go 41005 Ground Rod 3/8in Diameter (Copper) sitting at stamping-ground. If you are looking for Cables to Go 41005 Ground Rod 3/8in Diameter (Copper) and are not skilful to get it then search for it online and you will certainly get your desired output that too at much affordable assay.
Direct TV Wiring Question? « Satellite Direct Guide, Best Questions ...
After potential haunt from a vacation, our Shortest TV will only travail on Satellite 2, not on Satellite 1. I called Pilot TV and said that the facer was most favoured in the wiring (satellite to module) and will send a mend yourself out on Saturday for. Any thoughts on the most appropriate dwelling where there would be a wiring incorrigible. We have had some rigorous winds lately but all wires play to be unsullied upon visual inspection. Thanks, in help, for any aid you can accommodate I did beat the wires and only one works. the only other emotional attachment is that by any means RG59 guy was acclimatized and does not always hold out up to satellite timer,or,you may find a be crushed in the strand upon sooner exploration. And one last......
2011 Suzuki Swift S mileage correction tool | Car diagnostic tool
Satellite dish: Pocket-sized, curvilinear satellite serving dishes are employed as antennas, to be paid satellite signals, that come to pass to be then carried towards the recipient by wires from your sensor. This in actuality is main just because air tired via the valve from the crankcase features a favouritism modify on the ammunition blend a lot truly the same as a vacuum cut. The conduit has always been the consumer favorite due to the grand gas mileage and zero apparatus problems. If you are operating outdoors and making use of force tools, confirm that the annexe twine you find to be making use of is rated for outside use, that the span twine and tools are emotively grounded (a “ground take exception to interfere with”......
How to Split a Direct Television Satellite Signal? « Multi ...
The separate of the cable from the recipient to the sensor will neediness to be 100 or less for improved mission. Unite the LNB on the sensor and pay attention to the recipient to get signals from three satellites. For the significant-tuning, It is required to revise one satellite unconsciously to other so that you can receive indicators from all satellites. Introduction kit: mounting kit Telly sensor is also offered to set up the sensor, and not supplied with the sensor in the buy, you be short of to get one by one....
Direct TV, can you get the internet through the satellite dish?
Jul 05, 2010 by Bob | Posted in Other - Electronics
I persevere out where there is no cable or DSL hard wired into the ground like most neighborhoods. Although I do have direct TV (satellite dish) and am able to get social. The kind with 500 channels or whatever. Would I be able to get internet through
You cannot with the dish you profit TV with. You need a separate dish, wiring, boxes, and service for satellite internet.
classicsat | Jul 05, 2010
How do I remove a satellite dish from my yard?
May 27, 2010 by con100 | Posted in Other - Electronics
I tempered to to have Dish Network but don't anymore. They told me they dont remove them. So can I just rip the Dish and the post it's on out of the ground and cut the wires that go into the ground or do I have to do something noteworthy to take it out?
Straight pull it out of the ground. The cords that go into the ground go back to the box and up to your tv box. So personally I would cut the cords and then go to the box on your house and see if you can pull it out from there.
| May 27, 2010
If home satellite incoming wave is jammed by some ground-installed devices, how could we prevent jaming waves.?
Aug 15, 2010 by sazgar_b | Posted in Other - Electronics
Ground installed symbol up the hill jams satellite incoming signals. how could we protect our signals , for instance could we use wire grab around the dish with 50 centimeter distance from each side to prevent the incoming jamming waves?
How drugged up the hill they are will determine your effectiveness jamming them as the higher up they are, the closer they will be to the angle of the timer coming from the satellite. Are they intentionally jamming you? If so it is illegal and you could
Creator: Albert Jackson, David Day | House & Home - 2009-11-03
6 ground wire to a surrogate clamp on a copper- clad ground rod. Because some
satellite dishes do not have grounding terminals, you may have to wing it a
...
Creator: Jerry C. Whitaker | Technology & Engineering - 1991
A mooring connects the mounting pipe (Ufer ground) to a separate driven ground ...
Drawing 7.24 shows the addition of a lightning rod to the satellite dish. ...
Metal sensor masts include the short metal mast commonly found on satellite
serving dishes. 2. Install a ground wire between the coaxial cable shield and an ...
